Q1. What measurement modes does the ICS518 have?
A. The ICS518 provides four modes: FLOW MODE, CONSUMPTION MODE, AVG MODE, and TOTAL MODE.
Q2. What does FLOW MODE show?
A. FLOW MODE displays the real-time water flow in GAL/Min or L/Min.
Q3. What does CONSUMPTION MODE show?
A. CONSUMPTION MODE measures water consumption for a single watering session. The display resets after approximately 30 seconds without water flow, or when the measurement is manually reset.
Q4. What does AVG MODE show?
A. AVG MODE displays the average daily water consumption for the previous 7 days.
Q5. What does TOTAL MODE show?
A. TOTAL MODE records accumulated total water consumption until it is manually reset.
Q6. How do I switch between gallons and liters?
A. Go to FLOW MODE and press and hold the button for approximately 2 seconds.
Q7. How do I reset CONSUMPTION, AVG, or TOTAL?
A. Open the desired mode and press and hold the button for approximately 2 seconds.
Q8. Why does the display turn off by itself?
A. The ICS518 has an energy-saving standby function. The display automatically shuts off after more than approximately 1 minute without water flow or button operation.
Q9. What battery does the ICS518 use?
A. 1 × CR2032 button cell battery. The battery is included.
Q10. Does the ICS518 require an app?
A. No. All measurements described in the current manual are viewed directly on the device.
Q11. Does the ICS518 require Wi-Fi or a Gateway?
A. No.
Q12. What is the measurement tolerance?
A. The specified measurement tolerance is ±3%. The manual notes that this result was obtained under specific straight-pipe test conditions.
Q13. What is the maximum flow rate?
A. The manual specifies 2400 L/h (636 GPH).
Q14. What is the working pressure range?
A. 0.5–8 bar (7.25–116 psi).
Q15. Can I use the same connector in both the US and EU?
A. Use the connector that matches the local thread standard: USA uses NH, while EU uses BSP. Do not force incompatible threads together.
Comments
Please sign in to leave a comment.