Why is my HTV245 leaking from the inlet, and how can I fix it?

A:

The HTV245 with brass inlet and two brass outlets is designed to provide a durable, leak-resistant connection when installed correctly. If water is leaking from the inlet, the cause is usually related to thread sealing, installation method, water pressure, or component condition.

How to Properly Install and Maintain the HTV245

Applicable for Brass or Plastic Inlets & Outlets

• Seal the inlet connection

Apply Teflon® (PTFE) tape to the male threads of the water source before attaching the brass inlet. Wrap the tape clockwise several turns to ensure a proper seal. Tighten the brass inlet securely but avoid overtightening.

• Install the outlets

Connect hoses or irrigation lines to the two brass outlets. Ensure proper thread alignment and tighten securely without using excessive force.

• Install new batteries

Use new AA alkaline, non-rechargeable batteries only.
Use one battery brand and replace all batteries at the same time.
Do not mix old and new batteries or different brands.

• Test the valve

Turn on the water slowly and run a manual watering cycle to confirm proper operation and check for leaks at the inlet.

Why the HTV245 May Leak or Stop Working

• No or insufficient Teflon tape on the inlet threads
• Cross-threading during installation
• Overtightening that damages the brass inlet or brass outlets
• Worn or damaged internal seals
• Use of rechargeable, mixed, or low-power batteries
• Excessive water pressure
• Freezing damage

Tips for Reliable Operation

• Always use Teflon (PTFE) tape on inlet threads
• Tighten brass fittings securely but do not overtighten
• Use new AA alkaline, non-rechargeable batteries
• Keep water pressure within the recommended range
• Drain and protect the valve in freezing conditions

Need Assistance?

If you continue to experience issues with your HTV245, our support team is happy to help.

Phone (US): +1-833-381-5659
Email: Service@rainpointonline.com